1. The equipment should be placed on a level ground. For equipment with wheels, the brakes of the casters need to be opened to prevent the equipment from sliding.
2. Connect the power supply according to the rated voltage of the equipment.
3. When the equipment is in operation, do not reach into the inside of the equipment.
4. After the equipment is finished working, the power must be cut off before the machine can be disassembled and cleaned.
5. The circuit part cannot be washed. When disassembling and washing, be sure to pay attention to the parts scratching the arm.
Introduction to the operation and use of the meat pie forming machine:
1. Choose a flat table, put the patty forming machine firmly, and pull the chassis legs apart to make the machine panel easy to observe.
2. Insert the plug on the hand-held sensor head of the patty forming machine into the socket on the panel and tighten it. Pay attention to the positioning gap. 3. Insert one end of the plug of the power cord into the socket on the rear panel of the chassis, and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply.
4. Turn on the main power switch on the rear panel of the meat pie forming machine, press the power switch key on the panel, and the machine can work when the green indicator light of "ready" is on.
5. Press and hold the "setting button" button of the meat pie forming machine, and set it to an appropriate value, generally between 0.5-2.0 seconds.
6. Put the induction head on the container cover, press the start button on the handle, then the "heating" red indicator light is on, indicating that it is heating, do not remove the induction head, and remove the induction head after the "heating" red indicator light is off The next container can be sealed after the "ready" green indicator light is on or the buzzer inside the machine gives a short "beep" prompt.
7. Meat pie forming machine checks the sealing quality, according to different materials, diameter containers and production efficiency, properly modify the "setting button" to make the sealing quality good.
Post time: Feb-04-2023